Batting Bits, end

So I finished cutting the battings bits into smaller bits, 1" square or less - no I did not measure them to cut them- and stuffed them into a pillow case previously ravaged by Titan.

 I was then left with a cutting mat looking like this:

I searched "how to clean a fibre cutting mat" on youtube and found that if you rub the mat with this:

 

the fibre particles will come out.

This is what I've done so far

Definitely an improvement.  Rub a dub dub.

But I can cut on the mat back and may just use this one for future batting use as I have a large good mat for regular stuff.